Cleaning Your Cooler
We recommend cleaning your dispenser every three to six months. Here’s how!

• Unplug the electrical cord and remove the empty bottle.
• Remove EZ Load Insert (if installed). Drain any water through the spigot.
• Carefully fill the reservoir with boiling tap water. Wait 3 minutes. ALWAYS BE CAREFUL NOT TO SPILL BOILING WATER ON YOURSELF!
• Use rubber gloves and scrub brush to clean reservoir and EZ Load Insert. NEVER use steel wool or anything abrasive.
• Drain water through spigot. Pour more boiling water in reservoir, then clean spigots, body, and handles.
• Drain all water through the cold and hot spigots.
• Rise, dry and replace the EZ Load Insert and plastic top (if installed)
• Place full bottle of water on top.
• If you have a hot water dispenser, remove the air from the tank by opening the hot spigot until water flows freely. Plug in the unit and allow a few minutes for the water in your dispenser to heat up or cool down.
• Enjoy!

Cooler Leak
     99% of all leaks are caused by undetectable pin hole leaks in a bottle itself. To determine whether your cooler is leaking, please watch the cooler test video on this page.